Check the cable threw a cable tester or ping from a computer.

Test the cable: Check the continuity of both connectors each other. When you remove the cable from the crimper, that end is ready to use. There is also a locking tab that holds the plastic sleeve in place for a tight compression fit. The copper splicing tabs on the connector will pierce into each of the eight wires. The wires are too short.Ĭrimping the cable: Carefully place the connector into the Ethernet Crimper and cinch down on the handles tightly. The wires do not go all the way to the end of the connector. The wires should extend only 1/2 inch from the blue cut sleeve. Wrong way: The plastic sleeve is not inside the connector where it can be locked into place. Plastic sleeve should be inserted proper in connector. Carefully push all 8 unstrapped colored wires into the connector. Step 3: A straight cut across the 8 wires to shorten them to 1/2 Inch (1.3 cm) from the cut sleeve to the end of the wires by crimping tool. This configuration allows for longer wire runs. Note how the green pair is not side-by-side as are all the other pairs. It is highly recommend you duplicate the color order as shown on the left. STRAIGHT THROUGH Ethernet cables are the standard cable used for almost all purposes, and are often called “patch cables”. There is two kinds of Ethernet cable is used for communication. Each pin is identified by a number, starting from left to right, with the clip facing away from you. Introduction: There are four pairs of wires in an Ethernet cable, and an Ethernet connector (8P8C) has eight pin slots.

Ethernet Cable – Category 5e or CAT5e or CAT6.

It is used to download the any modification and which is made in graphics in engineering station.RJ45 cable also used for communicate the printer with computer.

RJ45 cable is used for connect the ALL HMI and engineer station through a switch to communicated each other.

Download crossover cable pinout